EN
15
cordless drill driver PSCS 11-12V
Switching the device on and off
The device has an infinitely variable speed control. The more
firmly you push the on/off switch (14), the higher is the speed.
1. Check whether the tool clamped in and the torque setting
selected are suitable for the intended application.
2. Check whether the workpiece is secured and the worktop
prepared correspondingly.
3. Press and hold the on/off switch (14) during screwing or
drilling.
ð
The device operates with the previously selected
settings.
ð
The LED work lamp (15) is illuminated.
14
15
4. Let go of the on/off switch (14) to stop the device.
ð
The LED work lamp (15) turns off.
Info
The motor has an integrated brake that quickly stops
the motor once you let go of the on/off switch (14).
Shutdown
1. Set the switch for clockwise/counter-clockwise rotation (5)
to centre position (lock).
2. If required, allow the device to cool down.
3. Remove the battery from the device (see Start-up chapter).
4. Remove the tool from the device (see Start-up chapter).
5. Clean the device according to the Maintenance chapter.
6. Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Accessories
Article number
Spare battery PSCS 11-12V
6.200.000.102
Screw bit set, 32-piece
6.200.001.001
Wood drill bit set, 15-piece
6.200.001.101
Metal drill bit set HSS,
15-piece
6.200.001.131
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the battery is correctly connected to the
quick charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the fuse (home).
•
Check the quick charger for damages. Should the quick
charger be damaged, stop using it. Contact the Trotec
customer service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
