EN
11
cordless rotary hammer PRDS 20-20V
Removing the battery
1. If necessary, push the additional handle (
14
) to the side
(see chapter Adjusting the position of the additional
handle).
2. Set the switch for clockwise / counter-clockwise
rotation (
3
) to centre position (lock).
3. Detach the battery (
8
) from the device by pressing and
holding the unlocking button (
12
, I.) and pulling the battery
off the device (II.).
I.
II.
8
12
4. If required, charge the battery (
8
) as described in the
section
Charging the battery
.
Checking the battery charging status
The battery comes with an integrated battery level indication.
The battery status is displayed as follows by the three LEDs of
the battery level indication (
11
):
LED colour
Meaning
Green – Orange – Red
maximum charge / power
Orange – Red
medium charge / power
Red
weak charge – Recharge the
battery.
1. Press on the battery icon (
18
) on the battery (
8
).
ð
You can read the battery status from the battery level
indication (
11
).
18
11
Tool change
The device comes equipped with an SDS-plus system tool
holder.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket and the battery from the device!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Please proceed as follows to remove or insert tools:
1. Set the switch for clockwise / counter-clockwise
rotation (
3
) to centre position (lock).
2. Push the SDS-plus system tool holder (
1
) to the rear,
remove the tool from the tool holder (if any) and let go of
the tool holder.
3. Insert the desired tool (e.g. SDS drill bit,
10
) into the SDS-
plus system tool holder (
1
) and, if necessary, slightly turn it
until it clicks into place.
1
10
4. Check the tool for tight fit.
