10
EN
cordless rotary hammer PRDS 20-20V
Charging the battery
Note
The battery can be damaged in case of improper
charging.
Remove the charger's mains plug before inserting or
removing the battery.
Never charge the battery at ambient temperatures
below 10 °C or above 40 °C.
The battery is partially charged upon delivery to avoid damage
to the battery caused by a deep discharge.
Prior to initial start-up and when the battery is low (only the red
LED in the battery level indication (
11
) is illuminated), the
battery should be charged. To do so, please proceed as follows:
1. Slide the battery (
8
) onto the quick charger (
6
) upside
down until it locks in place.
1,5 h
8
6
13
7
11
2. Insert the mains plug of the quick charger (
6
) into a
properly fused mains socket.
ð
The red battery LED (
7
) lights up.
ð
Charging requires approx. one and a half hours.
3. Wait until the red battery LED (
7
) goes off and the green
battery LED (
13
) lights up.
ð
The battery (
8
) is fully charged.
4. Hold onto the mains plug while pulling the power cable of
the quick charger (
6
) out of the mains socket.
ð
The battery (
8
) and the quick charger (
6
) may have
become warm during charging.
Allow the battery (
8
) to cool down to room temperature.
5. Take the battery (
8
) out of the quick charger (
6
) by
pressing and holding the release button (
12
) and pulling
the battery (
8
) off the quick charger (
6
).
Inserting the battery
1. If necessary, push the additional handle (
14
) to the side
(see chapter Adjusting the position of the additional
handle).
2. Set the switch for clockwise / counter-clockwise
rotation (
3
) to centre position (lock).
3. Slide the battery (
8
) onto the device until it locks in place.
8
