11
EN
Operating manual – cordless rotary hammer PRDS 10-20V
Tool change
The device comes equipped with an SDS-plus system tool
holder.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket and the battery from the device!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Please proceed as follows to remove or insert tools:
1. Set the switch for clockwise/counter-clockwise rotation (3)
to centre position (lock).
2. Push the tool holder (1) to the rear and hold it there.
3. Insert the tool (e.g. SDS drill bit, 7) into the tool holder (1).
1
7
4. Let go of the tool holder (1).
5. Check the tool for tight fit.
The SDS adapter (10) contained in the scope of delivery allows
you to use standard bits. In addition, you can fit the SDS adapter
with the extension with magnetic bit holder (11) contained in the
scope of delivery.
Please proceed as follows to use the SDS bit adapter:
1. Push the tool holder (1) to the rear and hold it there.
2. Insert the SDS adapter (10) into the tool holder.
1
9
10
19
3. Let go of the tool holder (1).
4. Check the SDS adapter (10) for tight fit.
5. Pull the lock (19) of the SDS adapter to the rear and insert
a bit (e.g. HSS drill bit, 9). Alternatively, you can insert the
extension with magnetic bit holder (11).
6. Let go of the SDS adapter lock (19).
ð
The tool holder of the SDS adapter (10) is locked.
7. Make sure that the tool is attached securely.
8. Push the lock (19) of the SDS adapter to the rear to remove
the bit or the extension with magnetic bit holder (11).
Info
The SDS adapter and the extension with magnetic bit
holder allow you to use commercially available bits.
