EN
10
Operating manual – cordless rotary hammer PRDS 10-20V
2. Insert the mains plug of the quick charger (12) into a
properly fused mains socket.
ð
The red battery LED (16) lights up.
ð
Charging requires approx. one hour.
3. Wait until the red battery LED (16) goes off and the green
battery LED (15) lights up.
ð
The battery (6) is fully charged.
4. Hold onto the mains plug while pulling the power cable of
the quick charger (12) out of the mains socket.
ð
The battery (6) and the quick charger (12) may have
become warm during charging.
Allow the battery (6) to cool down to room temperature.
5. Remove the battery (6) from the quick charger (12).
Inserting the battery
1. Set the switch for clockwise/counter-clockwise rotation (3)
to centre position (lock).
2. Slide the battery (6) onto the device until it locks in place.
6
17
Removing the battery
1. Set the switch for clockwise/counter-clockwise rotation (3)
to centre position (lock).
2. Detach the battery (6) from the device by pressing and
holding the unlocking button (17; I.) and pulling the battery
off the device (II.).
I.
II.
3. If required, charge the battery (6) as described in the
section
Charging the battery
.
Checking the battery status
The battery comes with an integrated battery level indication.
The battery status is displayed as follows by the three LEDs of
the battery level indication (6a):
LED colour
Meaning
Green – Orange – Red
maximum charge / power
Orange – Red
medium charge / power
Red
weak charge – Recharge the
battery.
1. Press on the battery icon (18) on the battery (6).
ð
You can read the battery status from the battery level
indication (6a).
6a
18
