9
EN
compressor PCPS 10-1100
Exchanging the nozzle
To blow up inflatable items, you can connect the following
nozzles to the compressed-air hose via the supplied nozzle
adapter (9).
No.
Description
23
To be used with inflatables fitted with a vent valve
24
To be used with inflatables fitted with a screw-on valve
25
To be used with standard valves with an inner diameter
of 8 mm or more
To connect one of the nozzles via the nozzle adapter, please
proceed as follows:
ü
The device is switched off.
1. Push the quick-release lever (22) at the hose (15) of the
compressed-air gun and insert the nozzle adapter (9).
2. Attach the desired nozzle (23, 24, 25) to the nozzle
adapter (9).
23
9
24
25
Connecting the blow-out adapter
To remove dust and dirt in poorly accessible locations, use the
blow-out adapter (16).
To connect the blow-out adapter (16), please proceed as
follows:
ü
The device is switched off.
1. If the compressed-air gun is already connected to the
compressor, disconnect it from the compressor first (see
chapter Disconnecting the compressed-air gun).
2. Use an open-end wrench (SW14) to disconnect the
hose (15) from the compressed-air gun (12) by unscrewing
it counter-clockwise.
3. Fit the blow-out adapter (16) into the internal thread and
fasten it clockwise.
4. Connect the compressed-air gun to the compressor again
(see chapter Connecting the compressed-air gun).
Operation
Tips and notes on handling the compressor
General information:
•
Keep the venting slots clear to prevent the motor from
overheating.
•
The device is not suitable for continuous operation. Over a
period of 10 minutes, do not use the device for more than
1.5 minutes in continuous operation. Allow the device to
cool down for the remaining time.
•
Only use intact, flawless valve adapters.
•
Do not use the device at temperatures below +5 °C, since
the motor becomes sluggish and can be difficult or
impossible to start up at these temperatures.
