11
EN
Operating manual – angle grinder PAGS 10-230
2. Turn the guard (8) into the working position. Make sure that
the open side of the guard points towards the workpiece.
The closed side of the guard must always point to the user.
8
3. Close the locking lever (12).
12
4. Check whether the guard (8) is properly locked in place. It
must be impossible to rotate the guard.
You can increase the clamping force of the lock by
tightening the adjusting screw (10).
10
8
Tool change
The cutting disc for metal is preassembled.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning of hot surface
The insertion tool might still be hot after the
application. Burn hazard when touching the insertion
tool.
Do not touch the insertion tool bare-handed!
Wear protective gloves!
To change the cutting disc, please proceed as follows:
ü
The spindle is at a standstill and the cutting disc is no
longer rotating.
1. Press the spindle lock (1) to block the gears.
2. Slowly turn the clamping nut (15) to the locking point until
the lock is fixed. Press and hold the spindle lock (1).
