Trotec PAC 3550 PRO, Operating Manual

Page: 13 / 22

EN 12 local air conditioner PAC 3550 PRO
Remote control
All settings of the device can also be made using the remote
control included in the scope of delivery.
Insert suitable batteries in the remote control (see chapter
Technical annex).
Info
After a longer period of non-use, the remote control
will switch to standby mode. Standby mode can be
terminated by pressing the
POWER button on the
remote control Please note that the device
automatically takes over the current settings from the
remote control.
18
29
30
23
28
35
34
19
24
21
31
20
22
26
33
32
36
No. Designation Meaning
18 TIMER button Automatic switch-on timer function in
increments of 1 hour (1 h to 24 h)
Automatic switch-off timer function in
increments of 1 hour (1 h to 24 h)
19 FAN button Setting the fan speed in 3 stages:
High, Medium and Low
Only enabled in
cooling and
ventilation mode.
20 UP button Increasing the target temperature
(17 °C to 30 °C) or
the number of hours of the timer (1 h
to 24 h).
21 Segment display Display of current room temperature
when in operation
Display of target temperature while
setting it
Display of timer
Display of error codes
22 DOWN button Decreasing the target temperature
(17 °C to 30 °C) or
the number of hours of the timer (1 h
to 24 h).
No. Designation Meaning
23 MODE button Selection button for the mode of
operation
automatic operation
cooling
ventilation
dehumidification
24 POWER button Power button:
Switching the device on or off
26 Timer indication Timer active
28 Battery indication Charging status of the batteries for
the remote control
29 Operating mode
indication
Auto = automatic mode
Cool = cooling
Fan = ventilation
30 Fan speed
indication
Low =
Medium =
High =
31 °C / °F button Switching temperature indication
between °C and °F
32 SWING button Adjusting the position of the
ventilation flaps
33 Operating mode
indication
Dry = dehumidification
34 Transmission
indication
Indicates transmission to the device
when the button is pressed
35 Remote control
transmitter /
receiver Communication between device and
remote control
36 Swing function
indication
Swing function active
Swing function
The swing function can only be activated via the remote control.
Using the swing function, you can adjust the position of the
ventilation flaps or activate continuous movement of the
ventilation flaps.
1. Press the SWING button (32).
ð
The ventilation flaps move up and down continuously.
ð
The swing function indication (36) is illuminated.
2. Press the SWING button (32) again to stop the ventilation
flaps in a certain position and to switch off the swing
function.
ð
The swing function indication (36) disappears.