6
EN
radiant heater IR 2400
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Remove the transport protection (
7
) from the grille of the
radiant heater.
7
4. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning of electrical voltage
Risk of injury due to incorrect assembly!
Local or national regulations may apply for installation.
We recommend to have the installation carried out by a
qualified electrician.
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Mounting the wall holder
ü
Use tools suitable for the intended task.
1. Screw the holder to the device using the four screws
supplied.
ð
The wall bracket can be rotated downwards
between 30° and 45°.
Installation
When installing the device, observe the minimum distances
from walls and other objects as described in the Technical data
chapter.
•
Do not install the device directly behind a door.
•
Never install the device in a way that it radiates directly
onto walls or other objects. Observe the minimum
distances from walls or other objects according to the
Technical data chapter.
•
Only install the device in a horizontal position.
•
Please note that the minimum distance to the front also
applies to objects mounted on the ceiling, e.g. fans, lamps
or sprinkler systems.
C
A
B
C
D
