15
EN
Operating manual – 3-in-1 multi-function sander PMSS 10-200
The non-binding values listed in the table below shall serve as a
point of reference for selecting the right sanding sheet for the
task at hand:
For processing paint and lacquer
layers or primers such as filler and
spackle
grain size: 40 – 240
For grinding off paint
coarse
40, 60
For sanding primer paint
medium
80, 120
For final sanding of primers before
lacquering
fine
180, 240
For processing any wood-based
material
grain size: 40 – 240
For pre-grinding e.g. of rough,
unplaned beams and boards
coarse
40, 60
For surface grinding and levelling of
small irregularities
medium
80, 100,
120
For fine and finish grinding of hard
wood
fine
180, 240
Switching the device on and off
Wear your personal protective equipment when working with
the device.
1. Slide the on/off switch (1) to
I
.
1
2. Position the device on the workpiece.
3. Lift the device off the workpiece before you switch it off.
4. To switch the device off, slide the on/off switch (1) to
0
.
1
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
If required, allow the device to cool down.
•
Remove the tool from the device (see Start-up chapter).
•
If attached, disconnect the dust extraction system from the
device.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
