EN
5
vane anemometer BA16
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Storage
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
protected from dust and direct sunlight
•
For storing the device, use the transport case included in
the scope of delivery in order to protect the device from
external influences.
•
The storage temperature is the same as the range given in
the Technical data chapter.
Operation
Inserting the battery
Note
Make sure that the surface of the device is dry and the
device is switched off.
24
25
1. Remove the cover (24) from the device.
2. Use the battery clip (25) to connect the new battery with
correct polarity.
3. Slide the cover (24) back on the device.
Switch-on and measurements
1. Press the Power button (8) for approx. 3 seconds.
ð
The display will be switched on and the device ready for
operation.
2. Hold the measuring sensor (1) into the area where the
measurement is to be performed. Ideally, the vane is
aligned precisely to the flow direction.
ð
The measured values for temperature and air velocity
are displayed in real time.
Note:
Note that moving from a cold area to a warm area can lead to
condensation forming on the device's circuit board. This
physical and unavoidable effect can falsify the measurement. In
this case, the display shows either no measured values or they
are incorrect. Wait a few minutes until the device has become
adjusted to the changed conditions before carrying out a
measurement.
Switching the display illumination on and off
1. Press the
HOLD
/lamp button (5) for approx. 2 seconds.
ð
The display illumination goes on.
2. Press the
HOLD
/lamp button (5) again for approx.
2 seconds.
ð
The display illumination switches off.
Setting the temperature unit
1. Press the
UNITS
button (6) for approx. 3 seconds.
ð
Depending on the setting the temperature
indication (10) changes to °C or °F.
Setting the air velocity unit
1. Press the
UNITS
button (6) until the desired unit is
displayed.
Entering the cross-sectional area for volumetric flow
measurement
In order to obtain a precise indication of the volumetric flow
measurement (CMM), the cross-sectional area of the opening to
be tested must be entered prior to measuring. To do so, use the
function
AREA
. The unit of the cross-sectional area is to be
specified in m². For entering the value of the cross-sectional
area please proceed as follows:
1. Switch the device off.
2. Press and hold the
HOLD
/lamp button (5) while switching
the device back on.
ð
The indication
SET AREA
will be appear on the display.
3. Press the
MAX / MIN
button (7).
ð
The decimal point will move.
4. Press the
HOLD
/lamp button (5).
ð
You can alternate between the digits, the selected
number flashes.
5. Press the
UNITS
button (6).
ð
The value of the selected digit changes.
6. Repeat the steps 4. and 5. until the value is set as desired.
