6
EN
humidifier B 7 E
Storage
Before
storing the device, observe the following:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Empty the water tank.
•
Empty the lower part.
•
Use a cloth to wipe all parts of the device dry.
•
Clean the device according to the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Adapter
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only put up the device in an upright, stable position on firm
ground.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that there are no moisture-sensitive objects in
the immediate vicinity of the mist nozzle, since water may
condense near the mist nozzle.
Filling the water tank
The water tank (
3
) should be filled with clear drinking water
before first use.
Note
Fill the device with clear drinking water only. The water
temperature must not exceed 40 °C.
Scented oil or other additives can damage the plastics
and the nebulizer membrane.
Info
If possible, change the water every 3 days to prevent
bacterial growth.
1. Open the lid with air outlet (
1
).
1
3
13
2. Fill clear drinking water (maximally 40 °C) up to the
MAX
indication inside the water tank (
3
).
3. Insert the SecoSan
®
Stick (optional accessory) (
14
) into the
water tank (
3
).
