6
EN
humidifier B 6 E
Storage
Before
storing the device, observe the following:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Empty the water tank.
•
Empty the lower part.
•
Use a cloth to wipe all parts of the device dry.
•
Clean the device according to the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Water softener
•
1 x Brush
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only put up the device in an upright, stable position on firm
ground.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are unrolled completely.
•
Make sure that there are no moisture-sensitive objects
located in the immediate vicinity of the mist nozzle, since
water may condense near the mist nozzle.
Filling the water tank
The water tank should be filled before first use or when the
lacking water
indication (16) lights up.
Note
Fill the device with fresh drinking water only. The
water temperature must not exceed 40 °C.
Scented oil or other additives can damage the plastics
and the nebulizer membrane.
Info
If possible, change the water every 3 days to prevent
bacterial growth.
1. Remove the mist nozzle (1) from the water tank.
2. Remove the water tank (2) from the device by lifting the
water tank at the transport handle (4).
Note that there may still be residual water left in the lower
part (3) if the device was used beforehand.
3
2
1
4
3. Turn the water tank over. Please note that the opening at
the transport handle must not be used to fill the tank! It is
the outlet for the water mist.
