8
EN
air cleaner AirgoClean® 350 E
Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
1. Press the
On/Off
button (
19
) to switch the device on.
ð
The device emits an acoustic signal.
ð
The device measures the air quality within 3 minutes.
The
PM2.5/Timer
indication (
22
) shows the current
particle load.
ð
The
Auto
LED (
16
) is illuminated. The symbol for
automatic mode (
26
) appears on the segment display.
ð
The
Speed/air quality
LEDs (
25
) are illuminated
according to the measured air quality and fan stage.
Setting the operating mode
The device comes with the following operating modes:
• Automatic mode
• Night mode
• Ventilation
Automatic mode
When in automatic mode, the device automatically detects the
air quality.
Please proceed as follows to set the automatic mode:
ü
The device is switched on.
1. Press the
Auto
button (
21
).
ð
The
Auto
LED (
16
) is illuminated. The symbol for
automatic mode (
26
) appears on the segment display.
ð
The device is running in automatic mode.
If the device is in automatic mode while it is getting dark, the
light detection function will automatically put the device into
night mode.
Once the ambient brightness increases, the device switches
back to automatic mode.
The
PM2.5/Timer
indication (
22
) shows the measured
PM2.5 value.
The
Speed/air quality
LEDs (
25
) are illuminated according to the
measured air quality and fan stage.
Air quality: fine dust value
Speed/air quality LEDs
fine dust value
Fine dust value
indication (PM2.5 value)
Illuminated in green
(very good air quality)
0–50
Illuminated in blue
(good air quality)
51–100
Illuminated in red
(medium air quality)
>100
Please proceed as follows to switch off the automatic mode:
1. Press the
Auto
button (
21
).
ð
The
Auto
LED (
16
) goes out. The symbol for automatic
mode (
26
) is no longer shown on the segment display.
ð
The device switches to ventilation mode.
Info
Automatic mode and virus filtration
Do not use the automatic mode if the device is used for
virus filtration!
The integrated sensors only respond to air pollution
caused by fine particulates, pollen or possibly
VOC (organic chemical compounds). The device cannot
determine the virus load inside the room. It is possible
that the automatic mode indicates a good air quality
even though the virus load in the room is very high.
Therefore, when using the device for virus filtration, we
recommend that you always select a fixed performance
level adapted to the room size or the required
circulation rate.
Night mode
Info
In night mode, the ionization function cannot be added.
In night mode, the control panel is dimmed and the device
generates an air current that is adapted to your sleep habits.
Proceed as follows to switch on night mode:
ü
The device is switched on.
1. Press the
Sleep
button (
30
).
ð
The
Sleep
LED (
17
) is illuminated. The symbol for night
mode (
26
) appears on the segment display.
2. Press the
Sleep
button (
30
) again to switch off the night
mode.
ð
The
Sleep
LED (
17
) goes out and the device switches to
the previously selected operating mode.
Ventilation
In
ventilation
mode, you can select all fan speeds manually.
Please proceed as follows to select the fan stages:
ü
The device is switched on.
1. Select the desired speed by pressing the
Speed
button (
20
).
ð
The
Speed
LED (
17
) is illuminated. The
Speed/air
quality
LEDs (
25
) are illuminated according to the
selected fan stage.