8
EN
air cleaner AirgoClean® 250 E
Setting the operating mode
The device comes with the following operating modes:
• Automatic mode
• Night mode
• Turbo mode
• Ventilation
Automatic mode
When in automatic mode, the device automatically detects the
air quality.
Please proceed as follows to set the automatic mode:
ü
The device is switched on.
1. Press the
Mode
button (
15
) until the
Auto
LED (
13
) is
displayed.
ð
The device is now running in automatic mode.
If the device is in automatic mode while it is getting dark, the
light detection function will react and automatically put the
device into night mode.
When the brightness increases, the display illumination will also
increase and the fan speed will return to the level last set.
The
Air quality fine dust value
LED (
18
) or the
Air quality
gaseous pollutants
LED (
19
) is illuminated.
Air quality:
fine dust value
Air quality
fine dust value
LED
Fine dust value
indication (PM2.5 value)
Illuminated in blue
(very good air quality)
0-55
Illuminated in green
(good air quality)
56-100
Illuminated in orange
(medium air quality)
101-150
Illuminated in red
(poor air quality)
>150
Air quality:
gaseous pollutants
Air quality
gaseous pollutants
LED
Illuminated in blue (very good air quality)
Illuminated in green (good air quality)
Illuminated in orange (medium air quality)
Illuminated in red (poor air quality)
Please proceed as follows to switch off the automatic mode:
1. Press the
Mode
button (
15
) until the
Auto
LED (
13
) goes
out.
ð
The device switches over to the next operating mode.
Info
Automatic mode and virus filtration
Do not use the automatic mode if the device is used for
virus filtration!
The integrated sensors only respond to air pollution
caused by fine particulates, pollen or possibly VOC
(organic chemical compounds). The device cannot
determine the virus load inside the room. It is possible
that the automatic mode indicates a "good air quality"
even though the virus load in the room is very high.
Therefore, when using the device for virus filtration, we
recommend that you always select a fixed performance
level adapted to the room size or the required
circulation rate.
Night mode
Info
In night mode, the ionization function cannot be added.
In night mode, the control panel is dimmed and the device
generates an air current that is adapted to your sleep habits.
Proceed as follows to switch on night mode:
ü
The device is switched on.
1. Press the
Mode
button (
15
) until the
Sleep
LED (
13
) is
displayed.
ð
The
Sleep
LED (
13
) is illuminated.
2. Press the
Mode
button (
15
) again to switch off the night
mode.
Turbo mode
Note
In turbo mode, the room air is automatically disinfected
by means of negative ions. This additional function is
only available with activated turbo mode.
In
turbo
mode, the fan runs at the highest fan speed.
ü
The device is switched on.
1. Press the
Mode
button (
15
) until the
Turbo
LED (
13
) is
illuminated.
2. Press the
Mode
button (
15
) again to switch off the turbo
mode.
Ventilation
In
ventilation
mode, you can select all fan speeds manually.
Please proceed as follows to select the fan stages:
ü
The device is switched on.
1. Select the desired speed by pressing the
speed
button (
16
).
ð
The
Speed
LED (
12
) of stage 1, 2 or 3 is illuminated.
ð
Each time the buttons are operated, an acoustic signal
is emitted.