8
EN
oil heater IDX 20 D / IDX 31 D / IDX 50 D
Assembling the support frames
Use 2 small screws each to affix the two support frames for the
wheels at the tank's front flanges.
Use 2 small screws each to affix the two support frames for the
transport handle at the tank's rear flanges.
Assembling the wheels
1. Push the axle through the openings of the two support
frames.
2. Attach both wheels to the axle.
3. Slide the washers onto the axle.
4. Secure the wheels on the axle by means of the split pins.
5.
The following step only applies to IDX 31 D und
IDX 50 D:
Fasten the wheel caps to the wheels.
Info
If necessary, the device can be disassembled again
(e.g. for storage). To remove the wheels from the axle,
you can carefully loosen the wheel caps (if available)
by means of a slotted screwdriver and then straighten
the split pins using pliers.
Mounting the transport handle
1. Use 2 large screws each to affix the transport handle at the
two support frames for the transport handle.
