EN
7
oil heater IDX 20 D / IDX 31 D / IDX 50 D
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a
transport handle and two wheels.
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
While
transporting the device, observe the following:
•
Slightly lift the device by the transport handle (2) until the
rear support no longer touches the ground.
•
Wheel the device to the desired position.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
Assembly and installation
Scope of delivery
IDX 20 D
•
1 x Device
•
1 x Transport handle
•
2 x Wheel
•
1 x Axle
•
2 x Split pin
•
2 x Washer
•
2 x Support frame for wheels
•
2 x Support frame for transport handle
•
8 x Small screw
•
4 x Large screw
•
1 x Manual
IDX 31 D and IDX 50 D
•
1 x Device
•
1 x Transport handle
•
2 x Wheel
•
2 x Wheel cap
•
1 x Axle
•
2 x Split pin
•
2 x Washer
•
2 x Support frame for wheels
•
2 x Support frame for transport handle
•
8 x Small screw
•
4 x Large screw
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Upon delivery the device is already partially preassembled. The
support frames, wheels and transport handle still need to be
mounted.
