Insert
Screw
Align key holes to screws
Light
Pan
Rotate
Insert
Screws
Align outermost holes
Groove
Nib
Align grooves with nibs
Rotate
Remove
one screw
Loosen
two screws
7. LIGHT/COVER INSTALLATION
Remove
three
screws
Plug In
Connectors
LED
Array
INSTALLATION IS COMPLETE
Remove three screws from the light pan.
Lift cover to motor aligning the opening of
the grooves to the nibs inside the lower plate.
Rotate cover clockwise to secure it to
motor assembly.
Remove one screw and loosen two screws
from the central hub.
Lift light pan to motor to engage the
large end of the key holes with the screws.
Rotate the plate slightly to engage two
screws in small ends of key holes.
Insert screw removed in step 1 and tighten
all three screws.
7a. Installing the Light Pan
7b. Installing the LED Array
7c. Installing the Light Cover
8. REMOTE SETTING
Plug in wire connectors, matching wire colors.
Lift LED array to light pan, aligning the
outermost holes in LED plate to the
outermost threaded holes in Light Pan.
Insert screws removed in step 1 and tighten
all three screws.
8A. Preparing Remote Control
Remove Battery Cover from Transmitter
Install 2 AAA Batteries
The model is equipped with dimmable LED array so
the Light selector switch should remain on DIM setting.
2
1
3
Off
Light
(On/Off,
hold for
Dimmer)
High Medium Low
L
E
A
R
N
S
W
IT
C
H
LI
G
H
T
ON
DIM
Light
On/Dim
Selector
8B. Remote Pairing Process
Transmitter and receiver must be paired to operate together,
or to reset after replacing either transmitter or receiver module.
(c
an also circumvent Radio Frequency Interference from another RF device.)
Pairing process is begun with power to the fan turned OFF at the breaker.
Turn on the power.
Within 30 seconds of restoring power,
press and hold the Learn Switch
button for 3 to 5 seconds,
using narrow tool, pen or pencil tip.
The light on the fan will flash 3 times when complete.
Slide the Battery cover back on.
Battery
Cover
L
E
A
R
N
S
W
IT
C
H
LI
G
H
T
ON
DIM
Learn
Switch
Battery
Cover
REMOTE FUNCTIONS
P5
