6. BLADE INSTALLATION
5. BLADE ARM INSTALLATION
6. Installing the blades
5. Installing the blade arms
Lay blade on top of blade arm aligning
the four holes in blade with
the four posts on blade arm.
Secure blade to blade arm with
blade screws and washers.
Repeat for remaining blades.
Raise blade arm to motor face,
aligning the holes to the motor.
Secure blade to blade arm with
blade arm screws.
Repeat for remaining blades.
Blade
Arm
Blade
Blade
Screws &
Washers
(4)
Canopy
Screw
Key Hole
Push up canopy until the screw still in the mounting bracket
is engaged with the large end of the keyhole on canopy.
Rotate canopy slightly until the screw head is engaged
in the narrow end of the key hole.
Insert the remaining canopy screw into the other hole,
and tighten both canopy screws.
4. Installing the canopy
Note: Two screws are pre-installed on mounting bracket for canopy
installation. You will need to remove one and loosen the other slightly.
4. CANOPY INSTALLATION
3. WIRING CONNECTIONS
White
From House
From Remote
From Fan
(AC-N)
Black
(AC-L)
Green
(For ground wire)
(From downrod)
(From mounting bracket)
Secure with twist-lock wire nuts.
Green
Green
White
Blue
Black
(For light)
Green Ground/Earth to Green from Downrod and Green from Hanging Bracket
Black Source to Black Input of Receiver
White Source to White Input of Receiver
Black Output from Receiver to Black Fan Wire
Blue Output from Receiver to Blue Fan Wire
White Output from Receiver to White Fan Wire
Make sure that all wires are secured inside wire nuts.
Note: Wires from house may vary in color and may not include ground wire (green).
After wiring is complete, collect wires neatly inside mounting bracket.
P4
