Chapter 1
Tropos 7320 Router Installation Guide
15
Mount the router on a wood pole
1.
Select a mounting location. You can attach the router to any wood brace.
2.
Attach the pole bracket to the wood brace with two 1/4-inch lag bolts that are at least 3 1/2
inches in length, making sure that the wood brace is level.
3.
Attach the sun shield of the router to the pole bracket with three 5/16-inch machine screws.
Insert one screw through the hole in the center back of the sun shield and the other two
screws through the curved slot tracks.
on page 12 shows the proper screw locations
on the back of the sun shield.
4.
Level the sun shield by rotating the unit along the curved slot tracks. A built-in level is
located on the left side of the shield. Tighten the screws.
5.
Slide the router into place with the antennas on top and secure it at the end with four #10-32
hex head machine screws.
To continue installing the router, see
“Connecting Cable Attached Antennas”
Tower Mounting
You can mount the router on an outdoor tower.
Note
At the antenna level, the router must be free from metal obstruction within a 4-foot radius (
).
FIGURE 8
Tower Mounting
trp_199
4'
Brackets not included
Channel stock
