ASSEMBLY STEPS (
CONTINUED
)
To avoid damage to the finish of your Cantilever
Umbrella Poles, prepare a smooth, non-scratch work
surface (shipping carton, a tarp or pool towels can
be used).
Place the Lower Pole on its side on your prepared
work surface. Align the open end of the Upper Pole
with the corner bracket of the Lower Pole so that the
Upper Hook on the Upper Pole is facing upward.
Insert the Upper Pole into the Lower Pole Corner
Bracket aligning the assembly holes in both poles.
Insert the Threaded Stud through the assembly holes
and install a ¾” Lock Washer and Hex Head Cap on
either side of the Threaded Stud. Fully tighten both
sides using the Hex Head Wrench.
Using (2) persons, lift the Upper Pole and Lower Pole
assembly to the vertical position. Place the square
plate at the lower end of the Lower Pole on to the
assembly of the Base Stand. Orient the Upper Pole
with Upper Hook so that the Assembly is facing away
from the Base Weights. Align holes of the square plate
with the threaded holes on the Base Stand. Using the
Hex Head Wrench, install (4) Hex Head Screws and
(4) 1 ¼” Washers. Fully tighten.
On the top of the Umbrella Top Frame Assembly with
Cover, locate the two (2) double-screw bolts. Using
(2) persons, lift the Umbrella Top Frame Assembly
with Cover upwards and insert the two (2) double-
screw bolts in to the slot on the Upper Hook. Ensure
that the Assembly is firmly seated in the Upper Hook
Slot. Tighten the screws to secure the Assembly to
the Upper Arm.
To assemble the lower and upper halves of the
Umbrella Cable, locate the two ends of the Cable.
Each of the (2) Cable ends has an oval Cable Protector
attached. Place the (2) ends of the Cable Protector
together and twist to screw the two halves together.
CANTILEVER
UMBRELLA
TROPITONE.COM
| 3
2.
3.
4.
5.
Summary of Contents for 7AS010CKD
Page 1: ...CANTILEVER UMBRELLA ...
