4. Installation
1
Loosen the screws
with the socket
wrench and remove
the touch screen
from the beam.
Remove the screws
and nuts.
Filament
bracket
Take the upper bracket and match the
four holes to the four holes of the
base. Use four M5*50 screws to lock
the upper bracket to the base.
Lock the ship nut
with socket wrench
and fix the touch
screen on the front
beam profile of the
base.
Note: the controller must be locked
on the front beam, otherwise it will
collide with the hot bed.
Take out the filament bracket, lock
the ship nut with hexagon wrench,
and fix the bracket on the upper
beam.
2
3
done
Pass the removed
screw through the
touch acreen
bracket and carry
the ship nut.
Note: Please make sure the voltage is consistent with the
local voltage before printing . If not, please adjust it (110V-
220V
）
6
