Load and unload filaments
：
After waiting for temperature up to 180
℃
, filament go through from
the filament detection, extruder and feed pipe to the nozzle until the
filaments are squeezed , as the following picture shows :
Straighten
Filament
Print test
：
Click
→
“
TEST FILE
”
→
，
Start printing
If the filaments cannot stick on the first layer or the nozzle hits the
hotbed crazy when printing, then the distance of the nozzle and
the hotbed is not suitable . Then please readjust the Z offset value.
Filament run
out detection
Extrusion
Feed pipe
Click
23/0
23/199
11
