Battery Replacement
WARNING:
Risk of electric shock. Proceed with extreme caution.
Before replacing batteries, disconnect all cords and wait 30
minutes.
Remove any metal objects such as wristwatches and jewelry.
Use properly insulated tools and handles.
Strictly follow the instructions stated to avoid possible damage
to the unit and injury.
(See separate document for complete instructions on battery
replacement)
1. Make sure that Tronix Explorer XT is turned OFF.
2. Remove the screws of the cover located at the sides and top portion of
the unit.
Remove the cover. Make sure to place all screws in a container to
avoid misplacement.
3.
Carefully disconnect the battery terminals located in the boost
converter and the battery converter side (the
S
cord that connects the
two batteries) located in the charger board side from the battery to
avoid short circuit.
NOTE:
Remember to position the wires to ensure correct installation
later.
4. Remove the charger board located at the sides of the batteries. The
charger board serves as DC charger of the batteries inside.
5. Remove the screw of the battery bracket and screw under the battery
casing
6. Remove the battery bracket and the battery at the same time.
7. Turn the unit to the other side and remove the boost converter board.
8. Remove the screw of the battery bracket and the screw under the
battery casing.
9. Slide the battery out of the battery casing.
10.
Securely place the new battery, sliding it to the battery casing.
Tighten the battery bracket screws and install the boost converter
board.
11.
Turn to the other side and make sure to place the batteries inside the
metal closure first. Reinsert the bracket screws and put back the
charger board before connecting the battery terminals and connector.
NOTE:
Make sure that the battery terminals will NOT touch the heat
sink. For safety, you can cover the area of the heat sink where the
