Tronair 02-7835C0100, Operation & Service Manual

Page: 6 / 37

Model: 02-7835C0100
25 Ton Axle Jack
08/2010 | Rev. 01 Page | 3
7.0 TROUBLE SHOOTING
TROUBLE PROBABLE CAUSE ACTION
Fluid leakage at pump piston or
pump body Damaged backup ring, o-ring, piston or pump
body
Remove piston and pump body. Inspect
for damage. Replace defective part(s).
Replace removed o-ring and backup ring
External fluid leakage at rams
Damaged o-ring, backup ring or inner cylinder
wall.
Remove rams as a unit from cylinder.
Inspect parts. Replace o-ring and
defective part(s)
Jack fails to lift rated load
Release valve not closed properly Fully tighten release valve
Low fluid level Fill to correct fluid level
Pressure relief valve improperly adjusted Adjust or replace release valve
Leakage at inlet or outlet check ball
Inspect valve body for wear or replace
valve body and check balls
Vent screw closed Open vent screw
Rams will not support load after
manual or pneumatic pump up
Leaking ram o-ring seals
Check for external leakage, if present
replace defective seal and back up ring
Leaking pressure check valve
Inspect valve body for wear or replace
valve body and check balls
Leaking pressure relief valve
Remove release valve, inspect ball and
ball seat in pump block. Replace effective
part(s)
Rams raise and fall with each
manual pump stroke
Release valve open Fully tighten release valve
Inlet check valve not seated or sticking
Pump rapidly to dislodge or replace valve
body
Pressure check valve not seated or sticking
Pump rapidly to dislodge or replace valve
body
Jack fails to lower
Ram locknut not loosened Raise jack ¼ inch and release locknut
Vent screw closed Open vent screw
O-Ring (pinched or rolled)
Replace o-ring and back-up ring, clean up
cylinder wall of debris
8.0 GUARANTEES/LIMITATION OF LIABILITY
Tronair products are warranted to be free of manufacturing or material defects for a period of one year after shipment to the
original customer. This is solely limited to the repair or replacement of defective components. This warranty does not cover the
following items:
a) Parts required for normal maintenance
b) Parts covered by a component manufacturers warranty
c)
Replacement parts have a 90-day warranty from date of shipment
If you have a problem that may require service, contact Tronair immediately. Do not attempt to repair or disassemble a product
without first contacting Tronair, any action may affect warranty coverage. When you contact Tronair be prepared to provide the
following information:
a) Product Model Number
b) Product Serial Number
c)
Description of the problem
If warranty coverage is approved, either replacement parts will be sent or the product will have to be returned to Tronair for
repairs. If the product is to be returned, a Return Material Authorization (RMA) number will be issued for reference purposes
on any shipping documents. Failure to obtain a RMA in advance of returning an item will result in a service fee. A decision on
the extent of warranty coverage on returned products is reserved pending inspection at Tronair. Any shipments to Tronair must
be shipped freight prepaid. Freight costs on shipments to customers will be paid by Tronair on any warranty claims only. Any
unauthorized modification of the Tronair products or use of the Tronair products in violation of cautions and warnings in any
manual (including updates) or safety bulletins published or delivered by Tronair will immediately void any warranty, express or
implied.
The obligations of Tronair expressly stated herein are in lieu of all other warranties or conditions expressed or implied.
Any
unauthorized modification of the Tronair products or use of the Tronair products in violations of cautions and
warnings in any manual (including updates) or safety bulletins published or delivered by Tronair will immediately
void any warranty, express or implied and Tronair disclaims any and all liability for injury (WITHOUT LIMITATION and
including DEATH), loss or damage arising from or relating to such misuse .
9.0 APPENDICES
APPENDIX I HC-2515 Hand Pump (8800 psi) Parts List
APPENDIX II Safety Data Sheet (SDS) Hydraulic Fluid (MIL-PRF-5606)
APPENDIX III Declaration of Conformity
APPENDIX IV Maintenance Schedule