Models: 02-0526C0110 & 02A0526C0110
5 Ton (4.5 Metric Ton)
Single Stage Jack
11/2004
−
AA
−
Rev. 02
- 1 -
This product can not be modified without the written approval of Tronair, Inc. Any modifications done without
written approval voids all warranties and releases Tronair, Inc., its suppliers, distributors, employees, or financial
institutions from any liability from consequences that may occur.
1.0 OPERATING
INSTRUCTIONS
Reference Figure 1 on Page 3. The user should be familiar with the following statements prior to using the
jack(s):
CAUTION!
1. Never put hands between the aircraft and the jack pad; as after aircraft has been lowered,
struts may have hung up.
2. Never align jack under aircraft by pounding on jack legs. Dented legs may lead to jack
collapse.
3. Always lower ram locking nut(s) after jack is under load. Be sure ram nut(s) is seated fully
after jacking.
4. Always raise and lower jacks simultaneously so that aircraft remains level.
5. Always use a tail or nose stand, as applicable, for additional stability.
1.1 RULES
FOR
OPERATING
1.
The user shall work in accordance with the Operators Manual.
2.
It is not allowed to work under the raised load until it is secured by suitable means,
i.e.
ram
locknut.
3.
The employer of the operator shall provide for all necessary training and give information
about pumping and translating forces.
4.
Operate between -20
Ε
C and 50
Ε
C/-4
Ε
F and 122
Ε
F.
1.2 JACK
INSTRUCTIONS
To Raise Aircraft:
1.
Place jack on a hard, level surface.
2.
Raise mechanical extension as close to aircraft jack pad as possible.
WARNING!
The locking pin MUST be placed in the ram protection ring groove and fully through the
mechanical extension.
The locking pin washer and ball lock MUST be placed outside the ram protection ring.
•
Do not place extra locking pins in
any other hole on the mechanical
extension.
•
Insure mating surfaces to jack
point are free of debris and
damage.
•
Under no conditions should the
locking pin washer or washer
groove be inside the ram
protection ring groove.
•
Under no conditions should the
locking pin’s ball lock be inside
the ram protection ring groove.
•
Never use the jack if the ram
protection ring is not installed.
1.2 Jack instructions continued on following page.
JACKING POINT
SURFACE
MECHANICAL EXTENSION
LOCKING PIN WASHER
AND WASHER GROOVE
LOCKING PIN
BALL LOCK
RAM PROTECTION
RING GROOVE
RAM PROTECTION RING
Summary of Contents for 02-0526C0110
Page 2: ......
