www.tron.com.tr 5
A4
A1
A3
Sign
Item Name
Description
A1
LED Indicator
(PWR
-
Power)
This LED blinks until the device gets ready for programing. Once the LED constantly green, this means
device is ready to be programmed.
A2
LED Indicator
(TS
-
Transport Stream)
Incase there is any problem ay any receiver side, this LED indicator doesn't flash at all. If all receivers
are working properly, LED will flash green continuously.
A3
Ethernet Connection Port
(LAN)
Used for the connection between PC and Divitron.
A4
RF Output (OUT)
Output connector for 4 DVB
-
C channel
Divitron Front Panel
B1
B2
B3
Sign
Item Name
Description
B1
SAT Inputs and Loops
(IN, LOOP)
Connect satellite signal (RF coaxial) cables from antennas to LNB IN connectors of each module of
Divitron.
Note: In the RF Tuner elements of your Divitron device, there are active looping from LNB IN to LNB
OUT (Loop connector). Successive loop more than one time may cause the RF signal level to shift out
of an acceptable limit and related module of the device may not function correctly.
Max. Loop number for each LNB is limited to 1.
B2
AC Power Input and Pow-
er Switch
AC power input socket (IEC 320 Compliant
-
Male) and simple power switch. Under the cover in the
middle of this part, there is located the high current protection fuse of the device and its spare. When
replacing it with a fuse other than its spare, make sure that it has the same voltage and current rating.
B3
(GND)
Grounding
The device must be earthed in properly.
Divitron Rear Panel
A2
Divitron
QAM 4x4—FTA
Mechanical Structure
&
Connection Ports
