INSTALLATION
Installed in exposed T35 profiles in removable, suspended ceiling system September 2010 Page 3
1:
Fix the perimeter angle profiles securely
to the wall with a max. spacing of 300
mm. Additionally, fasten 50 mm from
profile end at joints, abutments and
endings. (See figs. A and B). Hang the
main tee profiles in parallel at 600 mm,
with hanger points at max. 1200 mm.
There should be max. 300 mm from the
transverse wall to the first hanger. The
main and cross tees should lap on the
perimeter angle profiles.
2:
Fix the hangers securely to the struc-
Fix the hangers securely to the struc-
ture above. In order to facilitate
installing the Troldtekt panels, the
hanger should be min. 200 mm long.
In case of increased loads from e.g.
lighting fixtures, the hanger spacing
should be reduced. Fix heavy fixtures
etc. to the structure above. Cut the
main tee profiles at the wall and en-
sure that the slots are placed correctly
in relation to the cross tees near the
wall. Use a hacksaw or a profile cutter
to cut the profiles. Connect the main
tee profiles by inserting the tabs
through the slots on the tongues of
the main profiles. Then bend the tabs
back to lock. (See figs. C and D).
3:
Place the cross tees between the main
tee profiles by inserting the tongues of
the cross tees into the slots of the main
tee profiles, spaced at 150 mm. (See fig.
E). When you have installed the profiles,
check that all hangers are secure. Adjust
if necessary. Now lay the Troldtekt
panels in the grid.
4: Please note:
When installing 600 × 600
mm panels, it is important to ensure
that the wood wool fibres run mainly
parallel in one direction. To ensure a
uniform appearance, install the panels
so that the printed Troldtekt texts on
the back of the panels all run in the
same direction
600 mm
Variable
max. 600 mm
600 mm
max.
1200 mm
max.
300 mm
1200 mm
Adjustable hanger
Perimeter angle profile
Main tee profile
Cross tee
A
B
1
2
3
A 1
B 1