Trojan TR 12.8-110 Li-ion, User Manual

Page: 11 / 20

11
U S E R ’ S G U I D E
11
4.12 INDICATOR LIGHT (GROUP 24 AND GROUP 27 ONLY)
The Group 24 and Group 27’s built-in smart battery features include a battery status push button and indicator light on the
top of the case. After the button is pressed, the indicator light will show one of the following color patterns for five seconds:
The light will display this color pattern for five seconds after the button is pressed, and whenever the condition
changes during use.
When the battery is charging, the light will indicate the state of charge with a color pattern. If the indicator light is off
while charging the battery then it is not charging or it is almost fully charged.
4.13 CAN BUS
The Trillium Group 24 battery is equipped with a CAN bus interface to allow communication with other CAN-based
devices. The battery side connector information is as follows:
QUANTITY PART DESIGNATION MANUFACTURER
DTM AWG 20 Solid Pin 3 0460-202-20141 Deutsch
DTM Receptacle 1 DTM04-3P Deutsch
The user is responsible for selection and procurement of mating hardware and cabling, including the specified 120 Ω
termination between the CAN-H and CAN-L wires at each end of the CAN cable. Details on the functionality of the CAN
bus are contained in the Trillium CAN User’s Guide, available at
https://www.trojanbattery.com/literature. If required,
technical support is available as outlined at the front of this manual.
BATTERY LEVEL INDICATOR
PRESS
BATTERY
STATUS
100% 0% 20% 50%
SOLID LIGHT BLINKING LIGHT
LIGHT COLOR PATTERN BATTERY CONDITION
Solid Green 90% - 100% Capacity Remaining
Blinking Green 50% - 90% Capacity Remaining
Solid Yellow 35% - 50% Capacity Remaining
Blinking Yellow 20% - 35% Capacity Remaining
Solid Red 10% - 20% Capacity Remaining
Blinking Red 0% - 10% Capacity Remaining
Blinking Green and Red Battery is shut off