Trojan STAMINA 320, User Manual

Page: 14 / 25

14
QUICK SPEED:
Press QUICK SPEED buttons, walk for low speed, jog for medium speed and
run for high speed. These buttons enable you to reach a desired pre-set
speed quicker than doing it manually.
QUICK INCLINE:
Press QUICK INCLINE buttons, 3, 6 and 9, to reach a desired pre-set.
SAFETY KEY:
The SAFETY KEY needs to be properly connected to the Trojan Stamina 320
Treadmill. Without a SAFETY KEY the Trojan Stamina 320 Treadmill will not
be operational even if the power is switched on. You need to connect the
SAFETY KEY properly and clip the other end on your clothes as a safety
precaution. Please do not skip this requirement. During an emergency,
pulling off this SAFETY KEY will stop the Trojan Stamina 320 Treadmill
immediately for your safety.
FUNCTIONS AND OPERATIONS:
GETTING STARTED:
Make sure the correct power supply is being used and turn on the Trojan
Stamina 320 Treadmill power switch. The red power switch light should light
up. Be sure to connect the safety key. E0 error code will show if the safety
key has not been attached. Clip the other end of the safety key on your
clothes and you are ready to use the Trojan Stamina 320 Treadmill.
SELF-CHECKING:
When using the Trojan Stamina 320 Treadmill for the first time, it is necessary
for the Trojan Stamina 320 Treadmill to carry out a self-check:
• Remove the safety key, press and hold MODE, and then insert the safety
key. The Trojan Stamina 320 Treadmill now enters into the self-checking mode.
During this mode, pressing START/STOP can terminate the self-checking, but
this is not recommended.
QUICK-START:
• When you are ready, and the safety clip is on your clothes press the
START button to start the Trojan Stamina 320 Treadmill.
• The initial speed will be 1.0 km/h after the START button is pressed. You
can press SPEED “UP
↑
” or ”DOWN
↓
” or the QUICK SPEED buttons, walk
for low speed, jog for medium speed and run for high speed, to adjust your
desired speed between the range of 1.0 km/h and 16.0 km/h.
• You can press INCLINE “UP
↑
” or ”DOWN
↓
” or QUICK INCLINE buttons 3, 6
and 9 to adjust to the desired incline.
• Any time during use of the Trojan Stamina 320 Treadmill , you can press
START/STOP button and the speed will slow down gradually to 0 km/h. To
stop the Trojan Stamina 320 Treadmill immediately pull off the safety key.
INCLINE:
• The incline, except in HRC program, can be adjusted after start.
• The range of the incline is from 0 to IO levels.
• INCLINE control button - press INCLINE “UP ↑ ” or ”DOWN ↓ ” on the QUICK
INCLINE buttons 3, 6 and 9 to adjust the desired incline.
• The display shows the incline level, not the percentage of the incline.
CONSOLE FUNCTIONS