Trojan Stamina 315, User Manual

Page: 14 / 25

14
SAFETY:
The Trojan Stamina 315 Treadmill will not operate unless the safety key is
inserted into the Console. In the event of an emergency, pull the safety key
out and the Trojan Stamina 315 Treadmill will stop immediately.
FUNCTIONS AND OPERATIONS:
GETTING STARTED:
Power the Trojan Stamina 315 Treadmill on by plugging it into an appropriate
wall outlet, then turn on the power switch located on the front of the Trojan
Stamina 315 Treadmill below the motor cover. Ensure that the safety key is
installed, as the Trojan Stamina 315 Treadmill will not power on without it.
When the power is turned on, all the lights on the display will light up for a
short time.
SELF-CHECKING:
When using the Trojan Stamina 315 Treadmill for the first time, it is necessary
for the Trojan Stamina 315 Treadmill to carry out a self-check. Remove the
safety key, press and hold MODE, and then insert the safety key. The Trojan
Stamina 315 Treadmill now enters into the self-checking mode. During this
mode, pressing START/STOP can terminate the self-checking, but this is not
recommended.
QUICK-START OPERATION:
• Press and release START/STOP to activate the display (if it is not already on).
Note: Installing the safety key will also activate the console.
• Press and release START/STOP to begin belt movement at 1.0 km/h. Adjust
to the desired speed using the ‘+’ or ‘-’. You may also use the rapid speed keys
(WALK, JOG, and RUN) to adjust the speed. The speed range is from 1.0 km/h to
16.0 km/h.
• To slow the Trojan Stamina 315 Treadmill down, press and hold the ‘-’ key
until the desired speed is reached. You may also press the rapid speed adjust
keys: WALK, JOG or RUN.
• Whilst running press START/STOP and the running belt will gradually slow
down if the speed is above 1.5 km/h. If the speed is under 1.5 km/h, then it will
stop immediately.
• Whilst running press CLEAR to reset all numbers except the speed. Then
enter into manual mode.
• To stop the tread-belt, press and release START/STOP.
INCLINE:
• Incline may be adjusted at any time after belt movement has started.
• The incline range is from 0 to 1O levels.
• Press the ‘up’ or ‘down’ to achieve desired level of incline. 3 Quick Access
Incline keys of 3, 6 and 9 are also available to adjust the incline to these
specific incline values.
• The display will indicate incline percent as adjustments are made.
• Incline will remain in its position when display is turned off.
PULSE GRIP:
The Pulse (Heart Rate) Console window will display your current heart rate in
CONSOLE FUNCTIONS