Trojan INFERNO 300, Care Instructions And Assembly Manual

Page: 8 / 20

1377-8
5. MONITOR’S INSTALLATION INSTRUCTION
STEP 01
Before installing the two clamps onto the handle-
bar, please orient Clamp A & Clamp B as shown at
photos.
STEP 02
Fasten the top of the 2 clamps using a Hex Nut & a
Philip Screw of 20mm long.
STEP 03
Turn back the handlebar, and using a Self-Tapping
Screw of 20mmsing a long to fasten the bottoms of
two clamps.
STEP 04
Slide the monitor into the monitor clamps as illus-
trated.
STEP 05
Slide the RPM sensor into the sensor housing ,
please make sure the front endof the RPM sensor
to be 1-2mm away from the magnet to enable the
good induction.
STEP 06
Guide the sensor wire through the white plastic
holder, and bind it.
Congratulations !
You’ve installed the monitor successfully !