14
Programming the Locomotive
(Selectrix)
All of the parameters for the locomotive can be
changed as often as you like by reprogramming
the locomotive. The specifications for program-
ming the standard parameters can be found in
the instructions for your programming unit. The
66837 decoder has additional parameters that
offer the possibility of adapting the decoder even
more effectively to the special characteristics of
a particular locomotive. The settings done at the
factory for the additional values will cause the de-
coder to behave in the same manner as Selectrix
decoders previously available.
Important:
The additional values for the decoder can not be
programmed with the old 56 6841 00 program-
mer. The programming of the normal parameters
(address, etc.) can still be done without any
limitations.
Important:
The reading and writing of the additional values
overwrites the standard values for the decoder.
The standard values must therefore be entered
again after the additional values have been
processed.
Reading the Additional Values
The values are read by entering
00-1111 Programming Key
hence
Address
00
Max. speed
1
Delay
1
Pulse width
1
Stop area
1
and pressing the programming key.
Writing the Additional Values
Important:
Twp stop areas must always be set for program-
ming the expanded key values!
The values are written by entering
00 = VAI Programming Key
hence
Address
00
Max. speed
V (Velo)
Delay
A (Acce)
Pulse width
I (Impw)
Stop area
2 (Stop)
and pressing the programming key.
Summary of Contents for 66839
Page 1: ...66839...