Triumph Tiger 850 Sport 2020, Owner'S Handbook Manual

Page: 72 / 200

General Information
72
Each press of the buttons will adjust
the speed by 1 mph or 1 km/h. If
the buttons are held, the speed
continuously increases or decreases in
single digit increments.
Stop pressing the adjust button when
the required speed is shown in the
display.
Note
The cruise control set speed display will
flash until the new set speed has been
achieved.
If riding up a steep incline and cruise
control is unable to maintain the set
speed, the cruise control set speed
display will flash until the motorcycle
has regained the set speed.
An alternative way to increase the
speed in cruise control is to accelerate
to the required speed using the throttle
grip and then press the SET/- button.
Deactivating Cruise Control
The cruise control can be deactivated
by one of the following methods:
• Roll the throttle twist grip fully
forward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase speed by using the throttle
for more than 60 seconds.
Upon deactivation, the cruise control
light will go out in the tachometer but
the SET indicator and set speed will
still be shown in the display screen,
indicating that the cruise control set
speed has been stored.
The cruise control set speed can be
resumed as described on page 72,
provided the cruise control has not
been deactivated by turning the ignition
switch to the OFF position.
Resuming the Cruise Control Set
Speed
Warning
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result
in loss of motorcycle control and an
accident.
Cruise control will be deactivated if one
of the following actions has been taken:
• Roll the throttle twist grip fully
forward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase speed by using the throttle
grip for more than 60 seconds.
The cruise control set speed can be
resumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be traveling at a
speed between 19 to 100 mph (30 to 160
km/h) and be in 3
rd
gear or higher.
A stored set speed is indicated by the
word SET next to the cruise control
symbol in the display screen.