Triumph NTO-9AE, Assembly & Operation Instruction

Page: 5 / 35

PREPARATION
The installation of this lift is relatively simple and can be accomplished by 2 people in a few
hours. The following tools and equipment are needed:
•
12 quarts of Non-Detergent Hydraulic Oil SAE-10 AW 32 or other good grade
•
Chalk line and 12’ Tape measure
•
Rotary Hammer Drill with 3/4” Drill Bit. Core Drill ReBar Cutter recommended
•
4’ Level
•
Sockets and Open Wrench set, 1/2”thru 1-1/2”(1-1/8” for 3/4” Anchors)
•
Vise Grips
GENERAL INFORMATION
1.
Identify the components and check for shortages. If shortages are discovered, contact
us immediately . Save the shipping bolts for use in the installation.
2.
Lift location-check with building owner and /or an engineer when applicable. The lift
should be located on a relatively level floor 4” thick and 3,000psi concrete sufficiently
cured with no cracks within 38” and no seams with in 6” of the base plate. Remember any
structure is only as strong as its foundation.
Check for ceiling clearance- lifting height plus vehicle height if installing the Floor Plate Style
Lift. Check for clearance in the front and rear of vehicle when on lift.
Basic Specification
Description Capacity Lifting Time Overall Height Overall Width Between Posts
Floor Plate Style/
Asymmetric
9000Ibs 50 Sec 111” 134.63” 110”
Overhead Beam Style/
Asymmetric
9000Ibs 50 Sec 142” 134.63” 110”
Please also read the general information about this lift shown of Figure 1
for Floor Plate Style, Figure 2 for Overhead Beam Style and Figure 3 for
Asymmetric type.
5
Floor Plate/Overhead Style Lifts