6 of 8
12.
Connect the alarm/immobiliser wiring to the main
wiring harness connector.
1. Alarm/immobiliser connector
2. Main wiring harness connector
13.
Using the cable ties in the fitting kit, secure the
antennae and the reed-switch wiring harness to the
frame.
1. Antennae
2. Reed-switch harness
3. Cable ties
14.
Refit the battery and secure with the battery strap.
15.
Reconnect the battery, positive (red) lead first.
16.
Fit the rider's seat, as described in the service manual.
17.
Refit the side panel.
1. Side panel
2. Grommets
18.
Check all the functions of the alarm as detailed in the
user guide.
Note:
•
When satisfied that the alarm/immobiliser is
functioning correctly, the connection between
the alarm/immobiliser unit and the main wiring
harness must be made secure and tamper proof
with the heat shrink tubing.
•
Before disconnecting the battery, ensure that the
alarm is set to winter mode as described in the
user guide. This will prevent the alarm going off
when the battery is disconnected.
19.
Remove the seat, disconnect the battery, negative
(black) lead first and remove the battery from the
motorcycle.
1
2
cfoi
1
3
2
cfoj
Warning
To prevent the risk of the battery exploding and to prevent
damage to electrical components ensure that the battery is
removed from the motorcycle prior to the use of the heat
gun.
Failure to observe the above warnings may lead to
electrical damage and a fire hazard which could cause
personal injury.
Warning
The air from a heat gun, and the heat gun itself, are very
hot. Wear suitable protective gloves and do not point the
heat gun at any part of your body as serious burns to the
skin may result.
1
2
2
cfhl
