6 of 10
All Motorcycles
10. Remove the rear grab handle bolts and retain for
re-use.
1. Rear grab handle bolts
11. Ensuring the carriage plate mounting brackets are
aligned with the front holes, fit the carriage
mounting plate to the grab handles. Loosely install
the bolts removed from the grab handle earlier.
12. Fit the two M8 x 45 mm bolts from the kit through
the front holes of the carriage plate and into the
carriage plate mounting brackets. Do not fully
tighten at this stage.
1. Nut
2. Bolt, M8 x 45 mm
3. Grab handle bolts
4. Carriage plate
13. Tighten the carriage mounting bracket nuts to
20 Nm
.
14. Tighten the rear grab handle bolts to
20 Nm
.
1. Nuts
2. Rear grab handle bolts
3. Carriage plate
15. Remove the two M8 x 45 mm bolts, retaining them
for re-use.
16. Fit the rear rack moulding to the sliding carriage
plate and tighten the screws to
3 Nm
.
1. Rack moulding
2. Screws
T0966
1
1
2
3
4
Caution
Ensure that the mounting bolts for the sliding carriage
are fitted correctly with the shorter bolts to the rear.
Fitting the longer bolts to the rear will cause damage to
the rear light assembly.
1
2
3
1
2
2
