Bar mixer shower
10
FITTING THE RISER/FIXED HEAD RAIL
Mark the centre hole for the wall bracket
(fig.10).
Drill and plug the wall. The wall plugs are suitable
for most brick walls – use an appropriate masonry
drill, but if the wall is plasterboard or a soft building
block, use suitable wall plugs and an appropriate
drill bit.
Secure the bracket to the wall.
Note:
The elongated hole in the wall bracket
allows for a small amount of adjustment.
RISER KIT ASSEMBLY
Seat the upper part of the rail into the rail
support, making sure the bracket engages the
hexagonal fitting and the ‘O’ ring is in place
(fig.11)
.
Using a suitable screwdriver, tighten the retaining
screw to secure the rail into the support. Screw
the bottom part of the rail to the upper section
and tighten.
Note:
The upper and lower riser pipework
MUST
NOT
be cut. The product may not perform
within stated specifications if altered. Alterations
may invalidate the warranty.
FITTING THE SHOWER HEAD HOLDER
While depressing the button on the shower head
holder
(fig.12)
, slide the holder onto the rail
below the bracket.
Fig.10
Fig.11
Slider/holder
assembly
Press and hold
button to unlock
mechanism
Lower shower arm
Fig.12
Upper rail
Bottom rail
‘O’ ring
Rail support
Retaining
screw
