Super SeaSpy Camera
0514-SOM-00001, Issue: 02
14
© Tritech International Ltd.
5. Maintenance
5.1. General guidelines
After use in a marine environment the unit should be washed down with fresh
water in order to remove any salt build up.
Prior to stowing, the camera should be inspected for any signs of damage. If
the camera is damaged in any way it may be possible to fix it without replacing
the entire unit, contact
Tritech International Ltd
for more details and advice.
5.2. Dis-assembly and Re-assembly procedures
It may be necessary to open the Super SeaSpy in order to inspect the 'O' ring
surfaces, adjust the video amplifier, or to adjust the focus of the unit.
!
Warning
Maintenance of water integrity is the responsibility of the user.
Internal damage caused by water ingress is not covered by
product warranty unless the cause can clearly be identified as a
manufacturing defect.
To extract the main electronics of the Super SeaSpy camera perform the
following actions:
1. Unscrew the water block and disconnect it carefully
2. Extract the nylon cord fitted between the front part of the housing and the
camera body
3. Gently pull off the body, as straight as possible
4. Inspect all exposed 'O' ring surfaces and 'O' rings. If in any doubt change
the 'O' ring, clean and lightly smear with silicone grease
Re-assembly of the Super SeaSpy is completed in the reverse order. Ensure
that the water block 'O' ring is in position and that the water block is correctly
aligned with the main 6-pin DIN connector before pushing it gently back into
position.
To disassemble the water corrected port from the housing:
1. Unscrew the water block and remove it
2. Extract the nylon cord maintaining the port in position
