TriStar HD-2379 Instruction Manual Download Page 8

Page: 8 / 40

• For additional protection, we advise you to install a residual current

device (RCD) in the electrical circuit that supplies the bathroom his
electricity. This RCD must have a rated residual operating current no
higher than 30mA. Ask your installer for advice.

• This appliance is not intended for use by person (including children)

with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of appliance by a person responsible for
their safety.

• Children should be supervised to ensure that they do not play with the

appliance.

• If the supply cord is damaged, it must be replaced by manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

• WARNING: Do not use this appliance near water. Do not use this appliance

near bathtubs, showers, basins or other vessels containing water.
If this appliances has fallen into the water do not under no circumstances
directly grab this appliances but first pull the plug from the socket.

(*) Competent qualified electrician: after sales department of the producer

or importer or any person who is qualified, approved and competent to
perform this kind of repairs in order to avoid all danger. In any case you
should return the appliance to this electrician.

before the first use

• Take the appliance and accessories out the box.

Remove the stickers, protective foil or plastic from the device.

• Clean before use the appliance with a damp cloth.
• During first use there could be some smoke and a burning smell.

This happens because the appliance is new. It will disappear after
a few minutes. This does not mean there is a malfunction and it will
not cause one.

use

• Connect the power supply, press the “ON/OFF” switch to turn it on,

on the display will appear 150

˚c

• Set the temperature level between 100

˚c

and 200

˚c

to straight your

hair. Refer the table below for the correct temperature.

• Increase the temperature by pressing the “+” button and reduce

the temperature by pressing the “-“ button.

• For a complete styling, the hair should be clean, dry and free from dirt,

hair spray, creams, etc.

• Hair should be divided into several parts and operate part by part and

by even pulling the hair downwards. Comb through this section to
smooth out any snarls. Hold ends taut with one hand. Part off a section of
hair to be straightened, starting at the back neck area towards the crown,
moving along the sides and finishing at the front top area.

• Open the clamp and grip hair within one inch of scalp. Hold in place

for about 5 to 10 seconds for fine hair or 10 to 12 seconds for thick or
coarse hair.

• Carefully, release pressure on the handles and let the hair slip out from

the plates.

•    Repeat the treatment until you have a satisfied result.
•    After use, turn switch to the “OFF” position and unplug the appliance.
•  Allow the straightener to cool down.

iNstructioN maNuaL