7
Battery Replacement Door
Under normal conditions, the original batteries in your UPS will last
several years. Battery replacement should only be performed by
qualified service personnel. Refer to “Battery Warnings” in the Safety
section on page 2. When replacing batteries, qualified service
personnel should follow this procedure: 1) turn UPS OFF; 2) remove
the battery door located on the front panel; 3) pull batteries partially
out of the case; 4) make a detailed sketch of the batteries and the
polarity, color and connection of all cables; 5) disconnect battery
terminals; 6) dispose of used batteries; 7) reconnect replacement
batteries exactly as original batteries were; 8) push batteries back into
case and replace cover.*
* You may not receive full runtime until your replacement batteries have fully charged.
Specifications
Storage & Service
Storage
Turn your UPS OFF: first, engage the ON/Standby Switch and release it to place your
UPS in the “Standby” mode; then set the System Enable Switch* to “DISABLE”; finally,
disconnect the UPS power cord from the wall outlet. If you plan on storing your UPS
for an extended period of time, recharge the UPS batteries once every three months.
Follow steps #1 and #3 in the Installation section and allow the UPS to charge from
4 to 6 hours. If you leave your UPS batteries discharged for an extended period of time,
they will suffer permanent loss of capacity.
* The location of the switch varies by model. See page 3.
Service
If returning your UPS to Tripp Lite, please carefully pack the UPS using the
ORIGINAL PACKING MATERIAL that came with the unit. Enclose a letter describing
the symptoms of the problem. If the UPS is within the 2 year warranty period, enclose
a copy of your sales receipt.
SMART INT 1400 RM
SMART INT 2200 RM
Output Capacity (VA/Watts):
1400/940
2200/1750
Battery Runtime (Half Load/Full Load) Min.:
26/10
29/13
Battery Recharge Time:
2-4 hrs.
2-4 hrs.
Suggested Circuit:
15 amp
15- or 20- amp dedicated
Approvals:
UL, CE
UL, CE
SMART INT 2200 RM XL
SMART INT 3000 RM
Output Capacity (VA/Watts):
2200/1750
3000/2400
Battery Runtime (Half Load/Full Load) Min.:
29+/13+
23+/7+
Battery Recharge Time:
2-4 hrs.
2-4 hrs.
Suggested Circuit:
20-amp dedicated
30-amp dedicated
Approvals:
UL, CE
UL, CE
ALL MODELS:
Input Voltage/Frequency (230V/50-60 Hz); On Line Input Voltage Range (168 - 271 Volts); Voltage-Regulated Output Voltage Range
(230V ± 9%); On Battery Output Voltage Range (230V ± 5%); Output Waveform Line Mode (filtered sinewave); Output Waveform Battery Mode
(PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB); AC Protection Modes
(H to N, H to G, N to G).
The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change.
9905247 SmartPro Rackmount Owners Manual 230V.p65
4/13/00, 4:16 PM
7
Summary of Contents for SMART INT 1400 RM
Page 28: ...28 93 1414 9905247 0400...
