29
PD Alive Check Settings
State
Enables/Disables the global PD Alive Check.
Port
Selects a port or a range of ports which you want to configure.
State
Enables/Disables the PD Alive Check for the specific port(s).
IP Address
Specifies the Host IP address which connects to the port.
Interval
The interval to send the packet probes to check if the host is still
alive.
Retry Time
The retry times when no response from the host for the keep-a-live
probe packet.
Action
The action to the Power Device when the system detects that the
Power Device cannot respond the keep-a-live probe packet. The
options have
Reboot
/
Alarm
/
All
/
None
.
Power Off Time
When PD has been rebooted, the PoE port restored power after the
Power Off Time.
Start Up Time
The Switch waits the Start Up Time to do PoE Auto Checking when
the PD is rebooting.
Apply
Click
Apply
to take effect the settings.
Refresh
Click
Refresh
to begin configuring this screen afresh.
4.3.3.
Power delay
The Power Delay allows the user to setting the delay time of power providing after device
rebooted.
Notice:
The high priority port should have low value for power delay.
4.3.3.1.
CLI Configuration
Node
Command
Description
enable
show poe power-delay
This command displays the PoE power delay
configurations.
enable
configure terminal
This command changes the node to configure
node.
configure interface IFNAME
This command enters the interface configure
node.
interface poe power-delay
(enable|disable)
This command
enables
/
disables
of the Power
Delay function for the specific port.
interface poe power-delay time <0-300> This command configures the delay time of the
Power Delay for the specific port.
configure interface range
gigabitethernet1/0/
PORTLISTS
This command enters the if-range configure
node.
if-range
poe power-delay
(enable|disable)
This command
enables
/
disables
of the Power
Delay function for the range of ports.
if-range
poe power-delay time <0-300> This command configures the delay time of the
