Tripp Lite NGI-M08C4POE8-2, Owner'S Manual

Page: 285 / 326

285
Parameter Description
Community Name Settings
Community String
Enter a Community string, this will act as a password for requests from
the management station.
An SNMP community string is a text string that acts as a password. It
is used to authenticate messages that are sent between the management
station (the SNMP manager) and the device (the SNMP agent). The
community string is included in every packet that is transmitted
between the SNMP manager and the SNMP agent.
Rights
Select Read-Only to allow the SNMP manager using this string to
collect information from the Switch.
Select Read-Write to allow the SNMP manager using this string to
create or edit MIBs (configure settings on the Switch).
Network ID of
Trusted Host
Type the IP address of the remote SNMP management station in dotted
decimal notation, for example 192.168.1.0.
Mask
Type the subnet mask for the IP address of the remote SNMP
management station in dotted decimal notation, for example
255.255.255.0.
Apply
Click
Apply
to take effect the settings.
Refresh
Click Refresh to begin configuring this screen afresh.
Community Name List
Action Click Delete to remove a specific Community String.
9.1.2 SNMP Trap
9.1.2.1 Trap Receiver
9.1.2.1.1 CLI Configurations
Node Command Description
enable show snmp This command displays the SNMP configurations.
enable configure terminal This command changes the node to configure node.
configure snmp trap-receiver
IPADDR (v1|v2c)
COMMUNITY
This command configures the trap receiver’s
configurations, including the IP address, version (v1 or
v2c) and community.
configure snmp trap-ipv6-
receiver IPADDR
(v1|v2c)
COMMUNITY
This command configures the trap IPv6 receiver’s
configurations, including the IP address, version (v1 or
v2c) and community.