4
4. Setup
Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack or mount the charging station without
assistance. Use extreme caution when handling the charging station and be sure to follow all handling and installation
instructions. Do not attempt to install equipment without first stabilizing the charging station.
4.1 Power Requirements
4.2 Adjusting Storage Shelf Dividers
4.3 Connecting Devices and Powering the AC Unit
The charging station can be plugged into an AC outlet with a dedicated circuit. An AC outlet with a 20-amp (NEMA 5-20R) AC circuit is recommended
for powering the charging station. The AC outlet used to power the charging station should not be shared. The total wattage of the charging station and
all connected components should not exceed 1440 watts.
Your charging station comes with a storage
shelf containing adjustable dividers that can
accommodate up to 16 personal electronic
devices.
Remove any personal electronic devices stored
on the shelf tray. Then remove the blanking
panel by inserting your fingers into its left and
right holes, and lifting the blanking panel up
and pulling out
A
. To remove the shelf tray
from the cabinet, push the shelf tray forward to
disengage from the mounting hook, then pull
the tray up and out. Once the shelf is removed,
remove or rearrange the dividers by pushing in
the two tabs securing the divider to the rear
end
B
, then push the divider forward to
disengage from the shelf tray
C
. Repeat as
necessary for additional shelf dividers.
The charging station’s storage shelf features 16 strain relief bushings that prevent the devices’ power connectors from slipping through the bushing. If
the blanking panel has not been removed in
Section 4.2
, first remove the blanking panel by inserting your fingers into its left and right holes, and
lifting the blanking panel up and pulling out
A
. Connect the device’s power plug into one of the AC charger unit’s receptacles
B
, then run the power
connector through the storage shelf’s strain relief bushing to establish a power connection
C
. Repeat for all devices.
With the blanking panel removed, find the AC unit’s input plug and cable located in the charging
station’s bottom compartment, then push the input plug through one of the power cord access
holes located on either side of the charging station cabinet
D
(using the power cord access hole on
the same side as the power cord manager is recommended). Plug the power cord into the nearest
3-prong, grounded wall outlet and reattach the blanking panel to the unit.
Note:
The power cord can optionally be routed through the charging station’s rear panel. To do so, first remove
the rubber grommet from either
power cord access hole
and attach it to the
cable lock routing hole
on the
back of the unit (see
3. Feature Identification
for routing locations).
B
C
1
2
1
2
D
B
A
A
C
