5
1
Make sure that the HDMI and RS232 Serial source is powered off.
2
Connect the HDMI source to the HDMI Input port on the local transmitter unit.
3
Connect the included 3.5 mm Male-to-DB9-Female adapter cable to the
RS232 port on the local transmitter unit, and then connect the computer to the
adapter using a DB9 Serial cable.
4
Connect the IR-IN cable to the IR-IN port on the local transmitter unit.
Note
: Locate the IR-IN and IR-OUT units together in an area close to the
source being controlled by remote (e.g., Blu-Ray player).
5
Connect the IR-OUT cable to the IR-OUT port on the local transmitter unit.
Note
: Locate the IR-IN and IR-OUT units together in an area close to the
source being controlled by remote (e.g., Blu-Ray player).
6
Connect the external power supply to the local transmitter unit, and plug it into
a Tripp Lite Surge Suppressor, Uninterruptible Power Supply (UPS) or Power
Distribution Unit (PDU).
Installation Instructions
Note
: Test to make sure the entire installation works properly before pulling cables
through ceilings/walls. To achieve maximum distance and performance, use a
24Awg solid wire Cat5e/6 cable. Using a stranded wire Cat5e/6 cable, or a cable
with a gauge size higher than 24Awg, will result in shorter extension distance. All
Tripp Lite N202-Series Cat6 cables are made with 24Awg solid wire cabling.
201201216-93-3163.indd 5
2/9/2012 9:15:40 AM