Triplett CM200, User Manual, Page: 6 / 13

4. Touch the test leads to the circuit under test.
5. Read the voltage on the LCD display.
Resistance Measurements
1.
Set the function switch to the
V Ω CAP
position.
2.
Insert the black test lead banana plug into the negative COM jack.
Insert the red test lead banana plug into the positive jack.
3.
Press the MODE
button to indicate “ Ω ” on the display.
4.
Touch the test probe tips across the circuit or part
under test. It is best to disconnect one side of the
part under test so the rest of the circuit will not
interfere with the resistance reading.
6. Read the resistance in the display.
Continuity Measurements
1. Set the function switch to the
V Ω CAP
position.
2. Insert the black lead banana plug into the negative COM jack.
Insert the red test lead banana plug into the positive jack.
3. Press the MODE button to indicate“ " and “Ω” on the display
4. Touch the test probe tips to the circuit or wire you wish to check.
5. If the resistance is less than approximately 50
Ω, the audible signal will sound. If the circuit is
open, the display will indicate “OL”.
Capacitance Measurements
WARNING : To avoid electric shock, discharge the capacitor under test before
measuring.
1. Set the function switch to the
V Ω CAP
position.
2. Insert the black lead banana plug into the negative COM jack.
Insert the red test lead banana plug into the positive
V Ω CAP
jack.
3.
Use the
MODE
button to select
CAP
Measurements.