2. AC adaptor Jack
3. ON/OFF Button
4. MAX/MIN:
Press the button one time to
display the MAX (maximum)
reading . Press
again to display the MIN (minimum)
reading. A third press will exit MAX/MIN
mode. The meter will automatically exit
MAX/MIN mode in 10 seconds if no button
is pressed.
5. CH Input Jacks:
Insert the current or
voltage sensor to these ports to
measure
and record the data.
6. CHANNEL:
Select the channel for display on the LCD
7. START/STOP:
After the datalogger is setup from the software, press
The, START/STOP button for 4 seconds to begin recording. Press the
button again for 4 seconds to stop recording.
Recording cannot be started again until the data is
downloaded to the software!
8. USB Port
9. AC Current Clamp Jaw:
Clamp the jaws around a single
conductor for
AC current measurements to 200A
10.
Jaw Opening Trigger
11.
CH Plug
12.
AC Voltage Probes or Alligator
clips
13.
Voltage module
14.
CH Plug
