19
RESISTANCE MEASUREMENTS
X1 through X1K Ohms:
1. Insert the test leads into the appropriate jacks.
(Red to
6s/s-
, B
LACKTO#/-
)
2. Set Range Switch to appropriate
/(-3RANGE
.
3. Short test probes together.
4. Adjust
/(-3
ADJUST C
/.42/,
until meter reads
zero ohms.
5. Connect probes to the circuit or component to
be measured.
6. Read ohms on
/(-3
scale (multiply value read by
multiplier indicated by the switch).
7.
/PE
rate Polarity Switch to observe “forward” and
“reverse” resistance of the circuit or component.
If appropriate, observe the “capacitive kick” of the
circuit or component as the Polarity Switch is
operated.
A fuse protects the X1 range against accidental over-
loads. If the fuse should blow, all
/(-3
ranges will
not operate.
DO NOT TOUCH circuitry while
making measurements.
$)3#/..%#4
or
)3/,
A
4%
the device being tested from
other circuitry.
NOTE:
1K equals 1000.
www.
.com
1.800.561.8187