Triple S Ultron 18BA, Owner'S Manual

Page: 9 / 28

SSS Ultron 18BA 9
OPERATOR MANUAL
WaRnInG: Before performing any main-
tenance on the machine, be sure that the power
is turned off, or the batteries are disconnected!
WaRInG: Repairs are to be completed by
a triple S dealer only. any repairs completed
by unauthorized persons will void the warranty.
daIly maIntenance
1. Remove pad driver/ brush and clean with ap-
proved cleaner.
2. Drain recovery and solution tanks completely
and rinse out with clean water. Visually check
the recovery tank for debris and clean out as
necessary.
3. Raise the squeegee assembly off floor and wipe
it down with a damp towel. Be sure to store the
squeegee in the up position.
4. Remove the float shut-off assembly and rinse it
out with clean water.
5. Clean machine with an approved cleaner and a
damp towel.
6. Recharge the batteries.
7. Check the condition of the squeegee blade
wiping edge, rotate blade if worn.
montHly maIntenance
1. Clean the battery tops to prevent corrosion.
2. Check for loose battery cable connections.
3. Inspect and clean the recovery tank cover seal.
Replace it if damaged.
4. Lubricate all grease points and pivot points with
silicon spray and approved grease.
5. Check the machine for loose nuts and bolts.
6. Check the machine for leaks.
motoR maIntenance
1. Contact your Triple S Dealer for any motor
maintenance.
2. Motor should have the brushes checked every
250 hours. Brushes should be replaced when
they are worn to a length of 10 mm or less.
BatteRy maIntenance
WaRnInG: Batteries emit hydrogen
gas and an explosion or fire can result. Keep
sparks and fire away from batteries at all times.
WaRnInG: Whenever servicing batteries,
be sure to wear protective gloves. avoid con-
tact with battery acid at all times.
NOTE: For the best machine performance, keep
batteries properly charged at all times. Do not let
them sit in a discharged condition.
1. Always follow the battery charging directions as
outlined in the BATTERY CHARGING section of
this manual.
2. Keep battery tops and terminals free from corro-
sion. A strong solution of baking soda and water
is the best way to keep the batteries corrosion
free. DO NOT ALLOW THE BAKING SODA /
WATER SOLUTION TO ENTER THE BATTERY
CELLS.
3. Use a wire brush with the baking soda solution
to properly clean the battery posts and connec-
tions.
4. Check battery connections for wear and loose
terminals. Replace if necessary.
macHIne StoRaGe
1. Always store the machine indoors.
2. Always store the machine in a dry area.
3. Always store the machine in its upright position.
4. Always store the machine with the pad driver/
brush raised off the floor.
5. Always store the machine with the squeegee
assembly raised off the floor.
6. If storing in an area which may reach freezing
temperatures, be sure to drain all fluids from the
machine prior to storage. Any damage caused
by freezing temperatures will not be covered by
the warranty.
7. Drain the recovery tank.
8. Drain the solution tank of all fluid.
pReVentatIVe maIntenance