3
OPERATING PROCEDURES
WARNING! For the safe operation of this machine
follow the instructions given in this booklet and the
training given by your supervisor. Failure to do
so can result in personal injury and/or damage to
machine and property!
DO NOT OPERATE MACHINE IN AN EX-
PLOSIVE ENVIRONMENT!
WARNING! NEVER USE THIS MACHINE
TO PICK UP VOLATILE OR EXPLOSIVE
MATERIALS.
WARNING! DO NOT PICK UP WET
MATERIAL WITH THIS MACHINE.
The model shown in this manual is intended for commercial
use and for vacuuming dry material only.
ASSEMBLY
To prepare the machine for operation, make sure it is of
correct voltage and properly assembled. If in doubt, ask
your supervisor.
1. Place the brush head on a flat surface and latch the
swivel neck into the upright and locked position.
2. Turn the knob (Drawing 1, Item 57) located on tank
assembly counterclockwise to the right. Insert the tank
assembly over the projection ears on the lower unit while
keeping the tank in the vertical position. Return the knob
to the locked position by turning it clockwise.
3. Attach the flexible hose to the vacuum tank. The long
rigid portion of the flexible hose should be inserted into the
lower portion of the vacuum tank assembly.
OPERATION AS AN UPRIGHT VACUUM
1.
Properly install the filter bag in the vacuum:
Depress
the two white buttons on the back of the vacuum housing
door (Drawing 1, Item 8), then swing it up and open. Place
the bag into the opening with the notched portion next to
the handle tube.
2.
Plug the machine’s power cable into a properly
grounded outlet
(see Safety Instructions).
3.
Adjust the brush height
to suit the thickness of the
carpet. The adjustment ranges from positions 1 through 4:
Position 1 for very low pile carpet and Position 4 for very
high pile carpet. Adjust the height adjustment knob (Draw-
ing 2, Item 39) to the lowest number position that results in
the green light being on and the red light off (reference the
“Electronic Power Brush Monitor” section).
4.
Depress the foot pedal to lower the handle to the
operating position.
5.
Turn ON the switch
-the vacuum and brush motors will
start. Begin your DRY pick up vacuuming.
OPERATION with ACCESSORIES
1.
Properly install the filter bag in the vacuum.
2. Plug the machine’s power cable into a properly ground-
ed outlet.
3. Remove the rigid portion of the flexible hose from the
lower portion of the vacuum. The brush motor will auto-
matically stop when the hose is removed.
4. Attach the crevice or dusting tool to the wand, turn the
vacuum ON and begin.
5. Upon completion, reinsert the rigid portion of the hose
into its’ retaining hole.
Summary of Contents for PRO TWIN DELUXE 14
Page 5: ...NOTES 5 ...
